The
POLYDUCTOR is a high energy eductor. It is specifically
designed for polymer service. The Polyductor suction lifts,
disperses, and hydrates the polymer. It has a high suction
air-flow capacity. The high air flow causes the polymer
to enter the Polyductor at very high velocity. This results
in finer dispersion and better, faster hydration. Its surfaces
are continuously flushed to prevent polymer build-up.
Dilution water pressure range capacity of 40 to 100 psi
(2.7 to 6.8 bar).
ROTATING DISC FEEDER. It reliably feeds the polymer and
other difficult to handle materials. The disc continuously
vacuums itself clean to prevent build-up. The feeder is
enclosed. A clear door panel allows the operator to see
inside. All components are within easy access.
AIR HEATER / DRYER. It provides low humidity air to the
hopper and the feeder enclosure.
TEFLON CONVEYING TUBE. The tube is made of translucent Teflon.
It allows the operator to see the dry polymer flow. It's
non stick properties allow free flow even in high humidity
conditions.
NON-STICK SURFACES. The EXCELL makes maximum utilization
of surfaces which resist polymer sticking and are easy to
clean.
PROXIMITY SENSORS. Sensors monitor the polymer level on
the feeder disc.
PLC control simplifies changing operating parameters and
improves reliability.
Can be used with other dry products such as Potassium Permanganate
and clay.
This
model is for dry polymer feeding more than 300 PPD
This model is for dry polymer feeding less than 300 PPD
|
